Menu group „General“ contains the following general commands:
General
information about assignments, node coordinates, etc. |
|
Assign
group ID’s, color indices, etc. |
|
Define
name of layers |
|
Sort and renumber nodes and elements by position |
|
Shift
nodes on a regular surface |
|
Check conditions (vertex angle, orientation
etc.) of elements |
|
Stop |
Finish
application |
Exits
MAKROS if invoked from AutoCAD (AutoCAD command) |
|
Command
selection from MAKROS menu (AutoCAD command) |
|
Pass
control to AutoCAD |
With Information you get the information, which element types,
groups, IDs etc. exist in the active structure. With Assign IDs elements are assigned new group IDs, color
indices, etc., With Layer
names layer IDs
are assigned a text string, so that parts of the structure may be identified by
names. With Sort
Nodes, nodes and
elements may be sorted according to their geometrical position in the
structure. With Smoothing nodes may be shifted on to regular
surfaces. Compress
nodes serves the
purpose to fuse nodes, which are close together into a single node. Check elements allow checking the corner angles, distortion,
etc., of the elements.
Commands Element selection and Node selection allow defining and saving of selections for
the use with other command. Commands Control to AutoCAD and MAKROS are only available if the program
is started from within AutoCAD, it gives control back to AutoCAD and
conversely. Command Stop, respectively xunload when started from AutoCAD, ends the
application.